Pit Boss Error Codes (Full List + Causes + Solutions) - Simply Meat Smoking (2024)

Is your Pit Boss showing an error code? Don’t worry this is normal!

Below we have laid out all the common error codes for a Pit Boss. Then we will show you how to fix the problem and/or prevent it from happening again! If your looking for the PDF for the whole list of error codes stroll to the bottom and download it.

What Are Pit Boss Error Codes?

If you currently own a Pit Boss you would know that they’re reliable and easy to use. However error codes may appear on the grill’s control board display from time to time. There are about nine common codes that will usually pop up.

All of these codes have a solution to them, so do not fret. Plus each of these codes will indicate which part or section of your pellet grill needs checking, cleaning or fixing. For example, you might need to replace some parts, clear away build-up dirt, or even cool down your entire Pit Boss smoker.

We’ll go over some of the most common error messages that may appear on your Pit Boss and we’ll show you how to fix them too.

Pit Boss Error Codes Relating to the Temperature Probe

The Er1 error code, Pit Boss Err error code, and ErL error code indicate an issue with the temperature probe.

It shows that the electric pellet grill’s temperature sensor is malfunctioning. With this being said, there are multiple solutions to this issue.

Sure, we know that the temperature probe isn’t registering accurate temperature measurements. But this could be caused by a variety of factors.

For example, the probe may need cleaning. Or there could be a bad wire connection. And in some cases, the probe itself might need to be replaced.

If you’re wondering how to clean the temp probe on a Pit Boss, you need to use a screw driver to unscrew the bracket to access the RTD temp sensor, then use a damp soapy cloth to scrub off the thick residue, don’t get water on the electric parts and don’t yank on the sensor. Once done reattach and screw the brackets back.

Then if the issue still persists, you may want to reach out to the Pit Boss customer care team before replacing the temperature sensor.

Error Code Er2 — There’s an Issue With the Ignition

While this code is a lot more serious compared the error codes mentioned above, there is only a single solution for this problem.

You will need to replace the ignition in order for your pellet grill to be operable.

The Er2 code will appear only when your pellet smoker fails to reach the temperature range of 160 ℉ and above within the first half an hour of start up.

Unfortunately, your BBQ appliance won’t even function at all until you’ve fixed in a working ignition.

Error Code ErH — It’s Too Hot!

There are three triggers that will spur on this code — an issue with the grill temperature probe, the presence of excess fuel, or a grease fire.

In order to clear this ErH code, you should start by immediately shutting off your unit. After that, you’ll want to pull out all of the grill’s wires from the wall sockets.

Next, you should throw out any of the excess pellets from the pellet hopper.After that, you’ll want to clean the inside of the grill with a homemade mixture of salt and baking soda.

And lastly, you should check that the wire connections for the temperature sensor. It needs to be connected properly and safely secured.

Error Code ErP — Did You Shut Your Pit Boss Smoker Down Correctly?

You should not panic at all if you’re grill flashes an ErP code. This issue can easily be fixed. After this code just indicates that your Pit Boss wasn’t shut off properly.

For example, there might have been a power outage. Or, you might have switched off the power switch on the wall socket before making sure the grill was properly turned off.

You can easily remedy this problem by turning off the pellet smoker — simply press the smoker’s power button. After that you’ll want to wait for a solid two minutes before turning the appliance back on.

Nop Smoker Error Code — What Does It Mean?

This code is related to the smoker’s meat probe. These probes will allow you to monitor the internal temperature of your meats while you’re cooking.The simple solution to this problem is to check that the wires for these probes are connected properly.

If they are, but the error code still appears then you might need to replace the probes entirely.

Pit Boss Grill 4P1 Error Code

When this code pops up, it means that the grill’s control board is no longer syncing up with the program correctly. This will most likely happen if the control board’s been damaged in any way.

The good thing is that you’ll still be able to grill with your Pit Boss pellet grill, but the control panel’s display will most likely be inoperable.The solution involves replacing the control board or having it professionally looked at.

Pit Boss Error Code List PDF

If you would prefer to look at the errors codes in a pdf format you can download this error code list

Download Here: Pit Boss Error Code List PDF

And that’s it! You should now be fully knowledgeable of all of the smoker error codes on your Pit Boss, as well as know what they all mean.

While the little error messages might look intimidating at first, they’re actually really helpful.After all, they help point out which part of your cooking appliance needs cleaning, fixing or replacing.

Hi, I’m Charlie, I have been meat-smoking and grilling for the past 15 years. I have an array of different smokers, thermometers, and have a love for finding the right wood and charcoal combo My favourite recipes are my EXTRA CRISPY smoked pork belly, juicy pulled pork, smoked brisket, duck poppers, and ANY SEAFOOD I grill).

I loves sharing his tips with beginners, helping them navigate the world of smoking. I find it’s not just about cooking; it’s a quest for that perfect smoky flavor.

You will usually find me playing with the kids, perfecting my brisket bark, or sipping beers with boys around the fire. Can’t wait to share all my delicious smoking and grilling recipes with you!

You can read more about me on our About Us page.

• LinkedIn
• Facebook

Hungry For More?